EUTECH INSTRUMENTS WP PCD 650 Manual de Instruções descarregar pdf (Página 40)

Instruction Manual PCD 650

2.13 Transfer Measured Data to Computer (CyberComm)

2.13.1 Sending a single reading from multi measurement mode

1. Make sure that the CURRENT DATA SET parameter is set to ‘SINGLE’ in the

System Setup (Refer ‘System Settings – Page 4’ on page 79).

2. Make sure the CyberComm 600 application is up and running (page 12).

3. Make sure the IrDA port of the meter is closer and in-line with IrDA port of

the computer.

4. From multi measurement mode, press PRIN (F3) to send data to

CyberComm.

5. In CyberComm screen, press Find Device button. CyberComm starts

finding the meter.

6. When CyberComm finds the meter, press Connect button. The IrDA link is

established. The currently displayed measurement reading is transferred to

CyberComm. (Figure 31)

7. Select Row 1 data, Row 2 data or Row 3 data from below there

respective modes for which you wish to transfer data.

8. Once the data transfer is completed, the IrDA link is disconnected

automatically.

9. To send another reading, repeat step 3, 4, 5 & 6.

Figure 31 : Transferring a single measurement data (Multi measurement mode)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 119 120

Sem comentários

EUTECH INSTRUMENTS WP PCD 650 Manual de Instruções Página 40