EUTECH INSTRUMENTS WP PCD 650 Manual de Instruções descarregar pdf (Página 101)

Instruction Manual PCD 650

This page allows you to select alarm limits for resistivity measurement mode.

Parameter Description Factory Default

Alarm Set

Points

Set alarm limits for the resistivity measurement mode:

ENABLE – The measurement screen shows HI or LO

alarm indicators when the meter reading is above ‘HI

alarm value’ or below ‘LO alarm value’ specified in HI

& LO

Ω parameters (below)

DISABLE – HI and LO alarms are not shown in the

LCD

DISABLE

Hi Ω

Specify Hi alarm value here. The Hi alarm occurs

when the resistivity reading goes above this value

Available range: Lo Ω to 20.00 MΩ ohm

(This parameter is not editable when ‘ALARM SET

POINT’ is disabled)

2.00

Ω

Lo Ω

Specify Lo alarm value here. The Lo alarm occurs

when the resistivity reading goes below this value

Available range:0.000 to Hi

Ω

(This parameter is not editable when ‘ALARM SET

POINT’ is disabled)

1.00

Ω

) Press (Up) or (Down) arrow key to set high or low alarm point.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 119 120

Sem comentários

EUTECH INSTRUMENTS WP PCD 650 Manual de Instruções Página 101