EUTECH INSTRUMENTS DO 6 - REV 2 Manual de Instruções descarregar pdf (Página 37)

Instruction Manual CON 6/TDS 6

6.8 Restore Factory Default Values

This function allows you to reset all parameters to factory default settings. This

clears all calibration data and any other setup functions you might have

changed.

IMPORTANT: Once activated the meter’s settings and calibration data will be

erased and always exercise caution as meter reset is not reversible.

1) Enter the advanced setup as described in

Section 6.1.

2) Press ▲ or ▼ key until [UrSt] appears on the

LCD. Press ENTER key.

3) Press ▲ or ▼ key to select either [Yes] or

[no].

4) Press ENTER key to select.

5) The meter will go back to measurement mode

after the switch-on initialization as shown in

figure on Section 3.6. .

HOLD

ENTER

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Sem comentários

EUTECH INSTRUMENTS DO 6 - REV 2 Manual de Instruções Página 37