EUTECH INSTRUMENTS ALPHA CON 500 2-WIRE TRANSMITTER Instruções de Operação descarregar pdf (Página 19)

7.2 Setting temperature (Set

C) sub-function

7.2.1 Selecting automatic or manual temperature compensation

1) Enter Advanced Set-up mode by pressing the ENTER key.

2) Press the ∆

∆∆

∆ or ∇

∇∇

∇ keys to scroll until the

display shows “Set

C”.

3) Press the ENTER key. The lower display

shows “Atc”; the upper display shows “on” or

“oFF” depending on whether or not ATC is

selected.

4) Press the ∆

∆∆

∆ or ∇

∇∇

∇ keys to toggle between

ATC on and off.

5) Proceed with additional Advanced Set-up

procedures (press ENTER again) or return to

Measurement mode by pressing the ∆

∆∆

∆ and ∇

∇∇

∇

keys (escape) simultaneously.

7.2.2 Temperature calibration (ATC mode only)

1) Select “ATC on” as described above in

Section 7.2.1.

2) Press the ENTER key. The upper display

indicates the current temperature offset. The

current measured temperature is shown in the

lower display.

3) Compare the current measured temperature

on the controller display to a thermometer

known to be accurate. Note down the correct

temperature value.

0.0

0.00.0

0.0

25.0

ATC

SETUP

HOLD

onon

Atc

SETUP

HOLD

oFF

oFFoFF

oFF

Atc

onon

Atc

SETUP

HOLD

SETUP

SEt

SEtSEt

SEt

SETUP

HOLD

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Comentários a estes Manuais

Sem comentários

EUTECH INSTRUMENTS ALPHA CON 500 2-WIRE TRANSMITTER Instruções de Operação Página 19

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo EUTECH INSTRUMENTS ALPHA CON 500 2-WIRE TRANSMITTER