EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER (REVISION 3) Manual de Instruções descarregar pdf (Página 27)

8.6 Configure Temperature Settings – P4.0

Setup program P4.0 is for selecting ATC or MTC, set temperature coefficient values, and

select normalization temperature

P4.1: ATC or MTC mode (default : ATC mode)

P4.2: set temperature coefficient (default : 2.10 %)

P4.3: set Normalization temperature (default : 25.0

P4.0

P4.1 P4.2

P4.

TEMP COEF

NORM

MODEMODE

P4.1: Selecting ATC or MTC

1. Key in the password “022” as per procedure in Section 5.

2. Press ▲key until screen displays P4.0 and TEMP. Press ENTER.

3. Screen will scroll P4.1, MODE, then either ATC or MTC.

4. Press the ▲or ▼keys to select either ATC or MTC. Press ENTER.

5. Proceed to P4.2 or press the ▲and ▼keys together to return to P4.0. Press the

▲and ▼keys together again, to return to TDS measurement mode.

P4.2: Setting Temperature Coefficient

1. Key in the password “022” as per procedure in Section 5.

2. Press ▲key until screen displays P4.0 and TEMP. Press ENTER until screen

shows P4.2.

3. Screen will scroll P4.2, COEF., then 2.1 (to indicate 2.1%).

4. Press the ▲or ▼keys to change the temperature coefficient value. Press ENTER

to confirm.

5. Proceed to P4.3 or press the ▲and ▼keys together to return to P4.0. Press the

▲and ▼keys together again, to return to TDS measurement mode.

P4.3: Setting Normalization Temperature

1. Key in the password “022” as per procedure in Section 5.

2. Press ▲key until screen displays P4.0 and TEMP. Press ENTER until screen

shows P4.3.

3. Screen will scroll P4.3, then NORM, then 25.0.

4. Press ▲or ▼keys to change the normalization temperature value. Press ENTER

to confirm.

5. Press ▲and ▼keys together (ESCAPE) twice, to return to measurement mode.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Sem comentários

EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER (REVISION 3) Manual de Instruções Página 27